Ink won't adhere on metallized/plastic stock
High severitySymptoms
Ink scratches off with a fingernail after drying
Probable causes
- Non-absorbent substrate with low surface tension
- conventional ink instead of oxidative/UV
The Print Guy · 2026-10-05
Other problems in this category
Offset – Ink/Water · TPG-030
Ink over-emulsification
Washed-out colors, short ink that won't transfer, watery haze
Offset – Ink/Water · TPG-031
Tinting (ink in non-image areas)
Slight uniform tint across the whole sheet
Offset – Ink/Water · TPG-032
Scumming (localized greasing)
Ink marks in non-image areas, localized and persistent
Offset – Ink/Water · TPG-033
Excessive dot gain
Dark print, plugged shadows, lost detail
Offset – Ink/Water · TPG-034
Color variation during the run
Sheet 5,000 doesn't match the approved start-up sheet
Offset – Ink/Water · TPG-035
Slow drying
The pile won't dry; can't back up or finish